Citrix reciver 4.3 install#
Install the latest Citrix Receiver for Windows available at. Run the Receiver Cleanup Utility (see Knowledge Center article CTX137494 ) to remove the older version of Citrix Receiver completely. Record the existing customization to manually reconfigure it after the upgrade.
Citrix reciver 4.3 upgrade#
Unsupported upgrade to Receiver 4.xįor Citrix Receiver versions that have reached end-of-life (EOL), are SUPPORTED for in-place upgrades, or that are not shown in Table 1, the recommended upgrade procedure is as below: You can use the Receiver Cleanup Utility for a clean uninstall. If attempted at your own risk, ensure that the existing Version of Citrix Receiver is completely uninstalled before installing the older version. If Receiver was installed system-wide, users will not be able to upgrade that installation.ĭowngrading Citrix Receiver is not supported. Whether Receiver was installed at user-level (installed by users in their own profiles), it is not supported to run a system-wide upgrade as administrator: every single user will have to upgrade Receiver by themselves. Installation in user profile and upgrade Receiver can be installed at user (each user install in their own user profile) or system level. However, there have not been any reports of breakage: The following plug-ins are not tested for post-upgrade functionality by Citrix.
Citrix reciver 4.3 series#
Upgrading to the Receiver 4.x series Upgrade from Receiver 4.1 and later to the latest Receiver 4.x and above For instruction on upgrade, refer to the Upgrade Guide. Use Windows group policy to remove the older version and retain app shortcuts and other types of customization. Upgrade from Receiver 3.x Enterprise to Receiver 4.3 or earlier Note: When you upgrade Citrix Receiver for Windows from 13.x (non-Enterprise) or 4.2 to Version 4.2 or later, the /rcu switch is unnecessary and ignored.
![citrix reciver 4.3 citrix reciver 4.3](https://media.cdnandroid.com/item_images/11351/imagen-citrix-receiver-0big.jpg)
To run the Receiver Cleanup Utility when installing Citrix Receiver using a command line installation, run the following switch: The Receiver Cleanup Utility is run by default as part of Graphical User Interface installation. Upgrade from Receiver 3.x Enterprise to Receiver 4.4 or later
![citrix reciver 4.3 citrix reciver 4.3](https://www.jgspiers.com/wp-content/uploads/2016/03/2-8.jpg)
Beginning August 2018, Citrix Receiver has been replaced by Citrix Workspace app.